Home › Engine / Hybrid System › 2TR-FE (ENGINE CONTROL) › HEATED OXYGEN SENSOR
RM2850E _51 Engine / Hybrid System _073287 2TR-FE ENGINE CONTROL _0356947 HEATED OXYGEN SENSOR A

2TR-FE ENGINE CONTROL  HEATED OXYGEN SENSOR  INSTALLATION  


PROCEDURE

Hide 89465 1.INSTALL HEATED OXYGEN SENSOR

a.
A160994

Using SST, install the oxygen sensor onto the catalytic converter assembly.

Torque:
with out SST:

44 N*m (449 kgf*cm, 33 ft.*lbf)

with SST:

40 N*m (408 kgf*cm, 30 ft.*lbf)


NOTICE:
·

Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).

·

Do not damage heated oxygen sensor.

·

The tightening torque when using SST should be measured by arranging the torque wrench and SST linearly.




b.
A160993

Connect the heated oxygen sensor connector.


Hide 2.INSPECT FOR EXHAUST GAS LEAK