Home › Engine / Hybrid System › 2TR-FE FUEL › FUEL PUMP
RM2850E _51 Engine / Hybrid System _073289 2TR-FE FUEL _0356962 FUEL PUMP G

2TR-FE FUEL  FUEL PUMP  INSPECTION  


PROCEDURE

Hide 23221 1.INSPECT FUEL PUMP ASSEMBLY

a.

Check the resistance of the fuel pump.

i.
A161035E01
0.07,0.428 0.758,0.573 0.689,0.145 10 Ohmmeter

Using an ohmmeter, measure the resistance between the terminals.

Standard resistance:

0.2 to 3.0 Ω at 20°C (68°F)


If the resistance is not as specified, replace the fuel pump and/or lead wire.



b.

Inspect the operation of the fuel pump.

i.
A161036E01
3.097,0.791 3.205,0.944 0.108,0.154 10 1 3.035,0.507 3.143,0.775 false 2.677,0.791 2.785,0.944 0.108,0.154 10 2 2.848,0.507 2.74,0.775 false

Connect the positive (+) lead from the battery to terminal 1 of the connector, and the negative (-) lead to terminal 2. Check that the fuel pump operates.

NOTICE:
·

This test must be done quickly (within 10 seconds) to prevent the coil from burning out.

·

Keep the fuel pump as far away from the battery as possible.

·

Always do the switching at the battery side.


If the operation is not as specified, replace the fuel pump and/or lead wire.