1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2.DRAIN FUEL
77254D
3.DISCONNECT FUEL CHECK VALVE HOSE
Loosen the clamp and disconnect the fuel check valve hose.
77254D
4.DISCONNECT FUEL RETURN HOSE
Loosen the clamp and disconnect the fuel return hose.
77254D
5.DISCONNECT FUEL MAIN HOSE
Disconnect the fuel main hose.
Detach the 2 claws of the fuel tube connector retainer, push down the retainer and disconnect the fuel tube connector from the pipe as shown in the illustration.
| *a | Retainer |
|
Push |
|
Pull |
|
Pull Out |
If the fuel tube connector and the fuel pipe are stuck, push in and pull on the fuel tube connector to release it. Pull the fuel tube connector out of the fuel pipe carefully.
Check for any dirt and foreign matter contamination in the fuel pipe and around the connector. Clean if necessary. Foreign matter may damage the O-ring or cause leaks in the seal between the fuel pipe and fuel tube connector.
Do not use any tools to separate the fuel pipe and fuel tube connector.
Check for any dirt and foreign matter on the fuel pipe seal surface. Clean if necessary.
Do not forcibly bend, twist or turn the nylon tube.
Protect the disconnected part by covering it with a plastic bag and tape after disconnecting the fuel tube.
If the fuel pipe and fuel tube connector are stuck together, pinch the connector between your fingers and turn it carefully to free it. Then disconnect the fuel tube.
77213B
6.DISCONNECT FUEL TANK TO FILLER PIPE HOSE
Loosen the hose clamp and disconnect the fuel tank to filler pipe hose.
77254D
7.DISCONNECT BREATHER TUBE FUEL HOSE
Loosen the hose clamp and disconnect the breather tube fuel hose.
77100
8.REMOVE FUEL TANK ASSEMBLY
Disconnect the 2 connectors and the 4 clamps.
Set a transmission jack underneath the fuel tank.
Remove the 2 bolts and separate 2 fuel tank bands.
Slightly lower the jack.
77203A
9.REMOVE FUEL SUCTION TUBE SUB-ASSEMBLY
83320
10.REMOVE FUEL SENDER GAGE ASSEMBLY
Separate the 3 wire harness clamps.
Remove the 5 screws and the fuel sender gauge.
Remove the gasket from the fuel sender gauge.
77026A
11.REMOVE NO. 1 FUEL EVAPORATION TUBE SUB-ASSEMBLY
Remove the 8 screws, the nut and the No. 1 fuel evaporation tube.
Remove the 2 gaskets from the No. 1 fuel evaporation tube.
77380
12.REMOVE FUEL CUT OFF VALVE ASSEMBLY
Remove the fuel cut off valve from the fuel tank.
77420
13.REMOVE NO. 2 FUEL CUT OFF VALVE ASSEMBLY
Remove the fuel cut off valve from the fuel tank.
77213B
14.REMOVE FUEL TANK TO FILLER PIPE HOSE
Loosen the hose clamp and remove the fuel tank to filler pipe hose.
77254D
15.REMOVE BREATHER TUBE FUEL HOSE
Loosen the hose clamp and remove the breather tube fuel hose.
77011
16.REMOVE LOWER FUEL TANK FILLER PIPE SUB-ASSEMBLY
Remove the 8 screws and the lower fuel tank filler pipe.
Remove the gasket from the lower fuel tank filler pipe.
77651A
17.REMOVE NO. 1 FUEL TANK CUSHION
Remove the 9 No. 1 fuel tank cushions from the fuel tank.