Home › Engine / Hybrid System › 2TR-FE FUEL › FUEL SENDER GAUGE ASSEMBLY
RM2850E _51 Engine / Hybrid System _073289 2TR-FE FUEL _0356964 FUEL SENDER GAUGE ASSEMBLY G

2TR-FE FUEL  FUEL SENDER GAUGE ASSEMBLY  INSPECTION  


PROCEDURE

Hide 83320 1.INSPECT FUEL SENDER GAGE ASSEMBLY

a.

Check the fuel sender gauge assembly output voltage.

i.
A388386E01
1.615,0.115 1.781,0.115 1.781,0.115 1.896,0.563 true 2.188,0.594 2.677,0.594 true 0.115,0.052 0.427,0.25 0.313,0.198 10 false *a 1.354,0.042 1.667,0.24 0.313,0.198 10 false FE 2.729,0.51 3.042,0.708 0.313,0.198 10 false FV

Apply 5 V between terminals 1 (FV) and 2 (FE).

Text in Illustration
*a Component without harness connected
(Fuel Sender Gauge Assembly)
*b Voltage applied between terminals

NOTICE:
·

Be careful when connecting the leads, as the fuel sender gauge assembly may be damaged if the leads are connected to the wrong terminals.

·

Do not apply more than 6 V to terminals 1 (FV) and 2 (FE).



HINT:

If a stable power supply is not available, use 4 1.2 V nickel-metal hydride batteries or equivalent.




b.
A388385E01
0.938,1.063 0.938,0.635 true 0.323,0.583 0.667,0.583 true 0.479,1.406 0.823,1.406 true 1.115,3.146 1.458,3.146 true 0.083,0.51 0.396,0.708 0.313,0.198 10 false FR 0.083,0.094 0.396,0.292 0.313,0.198 10 false *a 0.854,1.104 1.167,1.302 0.313,0.198 10 false FE 0.375,1.292 0.688,1.49 0.313,0.198 10 false F 0.99,3.063 1.302,3.26 0.313,0.198 10 false E

Measure the voltage according to the value(s) in the table below.

Text in Illustration
*a Component without harness connected
(Fuel Sender Gauge Assembly)

i.

If the result is not as specified, replace the fuel sender gauge assembly.

Standard Voltage::
Tester Connection Condition Specified Condition

*: The output voltage changes depending on the voltage applied to the terminals.

2 (FE) - 3 (FR) Float position is F
(upper)
4.255 to 4.605 V*
Float position is E
(lower)
0.345 to 0.695 V*


HINT:
·

Output voltage(F) = (0.851 x Voltage applied to terminals) to (0.921 x Voltage applied to terminals)

·

Output voltage(E) = (0.069 x Voltage applied to terminals) to (0.139 x Voltage applied to terminals)