Home › Engine / Hybrid System › 2TR-FE EMISSION CONTROL › EMISSION CONTROL SYSTEM
RM2850E _51 Engine / Hybrid System _073290 2TR-FE EMISSION CONTROL _0356980 EMISSION CONTROL SYSTEM G

2TR-FE EMISSION CONTROL  EMISSION CONTROL SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT FUEL CUT-OFF RPM

a.

Start and warm up the engine.


b.

Increase the engine speed to approximately 3500 rpm.


c.

Using a sound scope, check the operation sound of the injector.


d.

Release the accelerator pedal. Check that the operation noise stops momentarily and then resumes.


Hide 2.VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS

a.
B000412

Check that there are no cracks, leaks or scratches on the hoses, connections or gaskets.

HINT:
·

Removing the oil level gauge, oil filter cap or PCV hose may cause the engine to malfunction or stall.

·

Disconnections, looseness or cracks in the parts of the air induction system between the intake system and cylinder head will allow air suction and cause the engine to run improperly.