Home › Engine / Hybrid System › 2TR-FE COOLING › COOLING SYSTEM
RM2850E _51 Engine / Hybrid System _073291 2TR-FE COOLING _0356992 COOLING SYSTEM G

2TR-FE COOLING  COOLING SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT COOLING SYSTEM FOR LEAK

a.

Remove the water filler cap.

CAUTION:

To avoid the danger of being burned, do not remove the water filler cap while the engine and radiator are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator.



b.
A156734

Fill the radiator with coolant and attach a radiator cap tester.


c.

Warm up the engine.


d.

Using a radiator cap tester, increase the pressure inside the radiator to 118 kPa (1.2 kgf/cm2, 17.1 psi), and check that the pressure does not drop.

If the pressure drops, check the hoses, radiator and water pump for leaks. If no external leaks are found, check the cylinder block and head.


e.

Reinstall the water filler cap.


Hide 2.CHECK ENGINE COOLANT LEVEL IN RESERVOIR

a.
A156735

The engine coolant should be between the L and F lines when the engine is cold.

If the coolant is below the L line, check for leaks and add TOYOTA Super Long Life Coolant (SLLC) or similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite, non-borate coolant with long-life hybrid organic acid technology up to the F line.

NOTICE:

Never use water as a substitute for engine coolant.



Hide 3.CHECK ENGINE COOLANT QUALITY

a.

Remove the water filler cap.

CAUTION:

To avoid the danger of being burned, do not remove the water filler cap while the engine and radiator are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator.



b.

Check if there are excessive deposits of rust or scale around the radiator cap and radiator filler hole. Also, the coolant should be free of oil.

If excessively dirty, replace the coolant.


c.

Reinstall the water filler cap.