*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
If the display indicates a communication fault in the GTS, inspect the DLC3.
When any CAN communication system DTCs are output, perform troubleshooting on the CAN communication system first.
| Proceed to |
|---|
| NEXT |
NEXT
Record or print DTCs and freeze frame data if needed.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
If the engine does not start, first perform the "check DTC" procedures and "conduct basic inspection" procedures below.
| Result | Proceed to |
|---|---|
| Malfunction does not occur | A |
| Malfunction occurs | B |
A
B
| Proceed to |
|---|
| NEXT |
NEXT
| Result | Proceed to |
|---|---|
| DTC is output | A |
| DTC is not output | B |
A
B
| Proceed to |
|---|
| NEXT |
NEXT
| Result | Proceed to |
|---|---|
| Malfunctioning parts not confirmed | A |
| Malfunctioning parts confirmed | B |
A
B
| Result | Proceed to |
|---|---|
| Malfunctioning circuit confirmed | A |
| Malfunctioning parts confirmed | B |
A
B
Check the ECM power source circuit (Click here Engine / Hybrid System>2TR-FE (ENGINE CONTROL)>SFI SYSTEM>ECM Power Source Circuit).
| Proceed to |
|---|
| NEXT |
NEXT
| Result | Proceed to |
|---|---|
| Malfunction not confirmed | A |
| Malfunction confirmed | B |
A
B
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT