Home › Engine / Hybrid System › 2TR-FE (ENGINE CONTROL) › SFI SYSTEM
RM2850E _51 Engine / Hybrid System _073287 2TR-FE ENGINE CONTROL _0357042 SFI SYSTEM D

2TR-FE ENGINE CONTROL  SFI SYSTEM  FREEZE FRAME DATA  


DESCRIPTION


A430071E01
1.031,0.875 0.896,0.396 0.896,0.396 2.167,0.875 false 0.896,0.417 1.594,0.885 false 1.885,0.042 2.865,0.219 0.979,0.177 10 false DTC is stored. 0.125,1.302 0.5,1.51 0.375,0.208 10 false Time 0.135,1.781 2.938,2 2.802,0.219 10 false ★ Freeze frame data which can be read 0.083,0.25 0.948,0.438 0.865,0.188 10 false 0.5 seconds

The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the engine was warmed up or not, whether the air fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.

The ECM records engine conditions in the form of freeze frame data every 0.5 seconds. Using the GTS, 5 separate sets of freeze frame data, including the data values at the time when the DTC is stored, can be checked.

HINT:

If it is impossible to replicate the problem even though a DTC is output, confirm the freeze frame data.

·

3 data sets from before the DTC was stored

·

1 data set from when the DTC was stored

·

1 data set from after the DTC was stored



These data sets can be used to simulate the condition of the vehicle around the time of the occurrence of the malfunction. The data may assist in identifying the cause of the malfunction, and in judging whether it was temporary or not.


LIST OF FREEZE FRAME DATA


Tester Display
Vehicle Speed
Engine Speed
Calculate Load
Vehicle Load
MAF
Atmosphere Pressure
Coolant Temp
Intake Air
Engine Run Time
Initial Engine Coolant Temp
Initial Intake Air Temp
Battery Voltage
Accel Sens. No. 1 Volt %
Accel Sens. No. 2 Volt %
Throttle Sensor Volt %
Throttle Sensor #2 Volt %
Throttle Sensor Position
Throttle Motor DUTY
Injector (Port)
Injection Volum (Cylinder 1)
Fuel Pump/Speed Status
Target Air-Fuel Ratio
AF Lambda B1S1
AFS Voltage B1S1
AFS Current B1S1
O2S B1S2
Short FT B1S1
Long FT B1S1
Fuel System Status #1
Fuel System Status #2
IGN Advance
Knock Feedback Value
Knock Correct Learn Value
VVT Control Status #1
VVT Aim Angle #1
VVT Change Angle #1
VVT OCV Duty #1
Starter Signal
Power Steering Signal
Power Steer. Sig. Record
Stop Light Switch
A/C Signal
Closed Throttle Position SW
Electrical Load Signal
Time after DTC Cleared
Distance from DTC Cleared
Warmup Cycle Cleared DTC
TC and TE1
ACT VSV
Idle Fuel Cut
FC TAU
Engine Speed of Cyl #1
Engine Speed of Cyl #2
Engine Speed of Cyl #3
Engine Speed of Cyl #4
Av Engine Speed of All Cyl