Home › Engine / Hybrid System › 2TR-FE (ENGINE CONTROL) › SFI SYSTEM
RM2850E _51 Engine / Hybrid System _073287 2TR-FE ENGINE CONTROL _0357042 SFI SYSTEM U

2TR-FE ENGINE CONTROL  SFI SYSTEM  FAIL-SAFE CHART  


If any of the following codes are recorded, the ECM entersfail-safe mode.

DTC No. Item Fail-safe Operation Fail-safe Deactivation Condition
P0031
P0032
Air-Fuel Ratio Sensor A/F sensor heater is turned off Ignition switch turned OFF
P0037
P0038
Heated Oxygen Sensor Heated Oxygen Sensor (HO2S) heater is turned off Ignition switch turned OFF
P0100
P0102
P0103
Mass Air Flow Meter If engine is running at over 3000 rpm, ECM performs fuel cut. "Pass" condition detected
P0110
P0112
P0113
Intake Air Temperature Sensor ECM fixes intake air temperature at 20°C (68°F). "Pass" condition detected
P0115
P0117
P0118
Engine Coolant Temperature Sensor ECM fixes engine coolant temperature at 80°C (176°F). "Pass" condition detected
P0120
P0121
P0122
P0123
P0220
P0222
P0223
P0606
P0607
P0657
P2102
P2103
P2111
P2112
P2118
P2119
P2135
Electronic Throttle Control System If electronic throttle control system is malfunctioning, ECM cuts off current to throttle actuator. Throttle control valve returns to predetermined throttle position (approximately 6.5°) by force of return spring.
Then, required engine power is calculated by using ignition timing and accelerator pedal position. Engine is controlled by intermittent fuel-cut. If accelerator pedal is depressed firmly and slowly, vehicle can be driven at minimum speed. If accelerator pedal is depressed quickly, vehicle may speed up and slow down erratically.
"Pass" condition detected and then ignition switch turned to OFF
P0325
P0327
P0328
Knock Sensor ECM sets ignition timing delay to maximum. Ignition switch turned OFF
P0351
P0352
P0353
P0354
Igniter If engine is running at over 500 rpm, ECM performs fuel cut in malfunctioning cylinders.Engine performs fuel cut in all cylinders if: 1) engine is running at over 1500 rpm, and 2) engine load rate is 20 to 89% or more. "Pass" condition detected
P2120
P2121
P2122
P2123
P2125
P2127
P2128
P2138
Accelerator Pedal Position Sensor Engine is stuck on idle or output is limited. "Pass" condition detected and then ignition switch turned OFF