Home › Engine / Hybrid System › 2TR-FE (LUBRICATION) › OIL LEVEL SENSOR
RM2850E _51 Engine / Hybrid System _073292 2TR-FE LUBRICATION _0357001 OIL LEVEL SENSOR G

2TR-FE LUBRICATION  OIL LEVEL SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89491 1.INSPECT ENGINE OIL LEVEL SENSOR

a.
A180713E02
2.333,0.708 3.115,0.344 false 2.438,0.885 3.125,0.917 false 2.979,2.375 3.208,2.552 0.229,0.177 10 false ON 2.948,2.927 3.24,3.104 0.292,0.177 10 false OFF 3.167,0.25 3.323,0.427 0.156,0.177 10 false 1 3.167,0.833 3.323,1.01 0.156,0.177 10 false 2

When the engine is started check that the oil level warning light comes on, and then goes off.


b.

While the oil level warning light is on, fill up with proper amount of engine oil.


c.

Check the oil level sensor when the oil level warning light is still after filling up with proper amount of engine oil.


d.

Remove the oil level sensor.


e.

Partially immerse the sensor in an oil bath and warm up the oil bath.


f.

Measure the resistance according to the value(s) in the table below.

A431350E01
1.896,1.26 2.021,1.469 false 1.25,1.115 1.323,1.448 true 5.698,2.292 5.698,2.5 false 1.188,1.479 2.104,1.677 0.917,0.198 10 false Sensor 2.094,1.406 3.01,1.604 0.917,0.198 10 false Float 0.531,1.948 3.302,2.417 2.771,0.469 10 false Temperature lower 1 to 15 °C (33.8 to 59 °F) than off temperature. ( 40 °C (104 °F) Min.) 3.427,0.365 4.479,0.594 1.052,0.229 10 false ON (Below 1 Ω) 5.979,0.75 6.469,1.01 0.49,0.26 10 false OFF 4.125,1.177 6,1.521 1.875,0.344 10 false 10 kΩ or higher 50 to 60 °C (122 to 140 °F) 5.583,2.531 6.5,2.729 0.917,0.198 10 false Float

Standard resistance:
Tester Connection Condition Specified Condition
1 - 2 ON, 20°C (68°F) Below 1 Ω
OFF, 20°C (68°F) Below 1 Ω
ON, 60°C (140°F) Below 1 Ω
OFF, 60°C (140°F) 10 kΩ or higher


HINT:

If the result is not as specified, replace the sensor.