1.REPLACE FRONT BEARING
Remove the 4 screws and bearing retainer.
Using SST and a press, press out the bearing.
Using SST and a press, press in a new bearing.
Install the bearing retainer with the 4 screws.
3.0 N*m ( 31 kgf*cm, 27 in.*lbf)
2.REPLACE REAR BEARING
Using SST, remove the bearing cover (outside) and bearing.
Be careful not to damage the fan.
Remove the bearing cover (inside).
Place the bearing cover (inside) on the rotor.
Using SST and a press, press in a new bearing.
Using SST, push in the bearing cover (outside).