Home › Engine / Hybrid System › 1HZ (CHARGING) › GENERATOR
RM2850E _51 Engine / Hybrid System _073312 1HZ CHARGING _0357076 GENERATOR G

1HZ CHARGING  GENERATOR  INSPECTION  


PROCEDURE

Hide 27370 1.INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

a.
A160023E02
0.646,0.698 1.125,0.875 0.479,0.177 10 false *a

Using a vernier caliper, measure the brush length.

Standard Length:

9.5 to 11.5 mm (0.374 to 0.453 in.)


Minimum Length:

4.5 mm (0.177 in.)


Text in Illustration
*a Length

If the length is less than the minimum, replace the generator brush holder assembly.


Hide 27330 2.INSPECT GENERATOR ROTOR ASSEMBLY

a.
A160024

Check that the bearing is not rough or worn.

If necessary, replace the generator rotor assembly.


b.

Check the rotor for open circuit.

i.
A160025E02
0.542,1.094 0.313,0.479 0.313,0.479 0.438,1.167 true 0.208,0.281 0.875,0.448 0.667,0.167 10 false *a 2.438,0.198 2.771,0.448 0.333,0.25 10 false *b

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Slip ring - Slip ring 20°C (60°F) 2.3 to 2.7 Ω


Text in Illustration
*a Slip Rings
*b Ohmmeter

If the resistance is not within the standard range, replace the generator rotor assembly.



c.

Check the rotor for a short circuit.

i.
A160026E02
1.625,0.615 1.417,0.813 false 0.792,1.531 0.573,1.24 false 1.646,0.5 2.021,0.667 0.375,0.167 10 false *b 2.417,0.24 2.802,0.427 0.385,0.188 10 false *c 0.844,1.479 1.438,1.646 0.594,0.167 10 false *a

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Specified Condition
Slip ring - Rotor core 10 kΩ or higher


Text in Illustration
*a Slip Rings
*b Rotor Core
*c Ohmmeter

NOTICE:

Perform the check on the fan portion of the rotor core that has not been coated with insulation paint.


If the result is not as specified, replace the generator rotor assembly.



d.
A160027

Using a vernier caliper, measure the slip ring diameter.

Standard Diameter:

14.2 to 14.8 mm (0.559 to 0.583 in.)


Minimum Diameter:

14.0 mm (0.551 in.)


If the diameter is less than the minimum, replace the generator rotor assembly.


Hide 27310B 3.INSPECT GENERATOR DRIVE END FRAME BEARING

a.
A157277

Check that the generator drive end frame bearing is not rough or worn.

If necessary, replace the generator drive end frame bearing.