27310B
1.INSTALL GENERATOR DRIVE END FRAME BEARING
Using SST and a press, press in a new generator drive end frame bearing.
Align the claws of the bearing retainer with the grooves inside the drive end frame.
| *a | Claw |
Install the bearing retainer with the 4 screws.
27330
2.INSTALL GENERATOR ROTOR ASSEMBLY
Install the generator rotor assembly and generator washer to the drive end frame.
27360
3.INSTALL GENERATOR COIL ASSEMBLY
Using a deep socket wrench (21 mm) and a press, slowly press in the generator coil assembly.
| *a | Deep Socket Wrench (21mm) |
Install the generator coil assembly with the 4 through bolts.
5.8 N*m (59 kgf*cm, 51 in.*lbf)
27370
4.INSTALL GENERATOR BRUSH HOLDER ASSEMBLY
While pushing the 2 brushes into the generator brush holder assembly, insert a φ1.0 mm (0.039 in.) pin into the generator brush holder hole.
| *a | Pin |
Install the generator brush holder assembly with the 2 screws.
Pull out the pin from the generator brush holder assembly.
| *a | Pin |
27387
5.INSTALL TERMINAL INSULATOR
Install the terminal insulator.
27039
6.INSTALL FRAME BRUSH COVER
Install the frame brush cover with the 3 nuts.
4.6 N*m (47 kgf*cm, 41 in.*lbf)
27411
7.INSTALL GENERATOR PULLEY
Install the generator pulley to the generator rotor shaft by tightening the generator pulley nut by hand.
Hold SST1-A with a torque wrench, and tighten SST1-B clockwise to the specified torque.
| SST1-A and SST1-B | 09820-06010 |
39 N*m (400 kgf*cm, 29 ft.*lbf)
| *a | Turn |
Check that the SST is secured to the generator rotor shaft.
Mount SST2 in a vise.
| SST2 | 09820-06020 |
Insert SST1-A and SST1-B into SST2, and attach the generator pulley nut to SST2.
| *a | Insert |
Tighten the generator pulley nut by turning SST1-A in the direction shown in the illustration.
133 N*m (1351 kgf*cm, 98 ft.*lbf)
| *a | Turn |
Remove the generator assembly from SST2.
Turn SST1-B, and remove SST1-A and SST1-B.
| *a | Turn |
Turn the generator pulley, and check that the generator pulley moves smoothly.