27411
1.REMOVE GENERATOR PULLEY
Mount the generator assembly in a vise between aluminum plates.
Install SST 1-A to the generator pulley shaft.
| Item | Part No. |
| SST 1-A and SST 1-B | 09820-06010 |
Install SST 1-B to SST 1-A.
Hold SST 1-A with a torque wrench and turn SST 1-B clockwise with the specified torque.
39 N*m (400 kgf*cm, 29 ft.*lbf)
Make sure that SST is secured to the generator rotor shaft.
| *a | Hold |
| *b | Turn |
Insert SST 2 and attach it to the generator pulley nut.
| Item | Part No. |
| SST 2 | 09820-06021 |
| *a | Insert |
To loosen the generator pulley nut, turn SST 1-A in the direction shown in the illustration.
To prevent damage to the rotor shaft, do not loosen the generator pulley nut more than one-half of a turn.
| *a | Hold |
| *b | Turn |
Remove SST 2 from the generator assembly.
Turn SST 1-B in the direction shown in the illustration and remove SST 1-A and B.
| *a | Hold |
| *b | Turn |
Remove the pulley nut and generator pulley.
27039
2.REMOVE REAR GENERATOR END COVER
Remove the 3 nuts and rear generator end cover.
27387
3.REMOVE TERMINAL INSULATOR
Remove the terminal insulator.
27370
4.REMOVE GENERATOR BRUSH HOLDER ASSEMBLY
Remove the 2 screws and generator brush holder assembly.
27360
5.REMOVE GENERATOR COIL ASSEMBLY
Remove the 4 through bolts.
Using SST, remove the generator coil assembly.
| *a | Hold |
| *b | Turn |
27384
6.REMOVE WASHER
Remove the washer.
27330
7.REMOVE GENERATOR ROTOR ASSEMBLY
Remove the generator rotor assembly from the generator drive end frame.
Do not drop the generator rotor assembly.
Inspect the generator drive end frame bearing.
Check that the generator drive end frame bearing is not rough or worn.
If necessary, replace the generator drive end frame bearing.
27312
8.REMOVE RETAINER PLATE
Remove the 4 screws and retainer plate.
27310B
9.REMOVE GENERATOR DRIVE END FRAME BEARING
Using SST, tap out the generator drive end frame bearing.