27370
1.INSPECT GENERATOR BRUSH HOLDER ASSEMBLY
Using a vernier caliper, measure the brush length.
9.5 to 11.5 mm (0.374 to 0.453 in.)
4.5 mm (0.177 in.)
|
If the length is less than the minimum, replace the generator brush holder assembly. |
|
| *a | Length |
27330
2.INSPECT GENERATOR ROTOR ASSEMBLY
Check that the bearing is not rough or worn.
If necessary, replace the generator rotor assembly.
Check the rotor for open circuit.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Slip ring - Slip ring | 20°C (60°F) | 2.3 to 2.7 Ω |
|
If the resistance is not within the standard range, replace the generator rotor assembly. |
|
| *a | Slip Rings |
| *b | Ohmmeter |
Check the rotor for a short circuit.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
|---|---|
| Slip ring - Rotor core | 10 kΩ or higher |
| *a | Slip Ring |
| *b | Rotor Core |
| *c | Ohmmeter |
Perform the check on the fan portion of the rotor core that has not been coated with insulation paint.
If the result is not as specified, replace the generator rotor assembly.
Using a vernier caliper, measure the slip ring diameter.
14.2 to 14.8 mm (0.559 to 0.583 in.)
14.0 mm (0.551 in.)
If the diameter is less than the minimum, replace the generator rotor assembly.
27310B
3.INSPECT GENERATOR DRIVE END FRAME BEARING
Check that the generator drive end frame bearing is not rough or worn.
If necessary, replace the generator drive end frame bearing.