CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY
Measure the resistance and voltage according to the below table.
| Terminal No. (Symbols) | Wiring Color | Tester Description | Condition | Specification |
|---|---|---|---|---|
| J12-2 (AC1) - Body ground | LG - Body ground | Idle-up request signal | ·
Engine idling ·
Blower switch: LO ·
A/C switch: OFF → ON (magnet clutch ON) |
11 to 14 V → Below 1 V |
| J12-3 (PRS) - Body ground | P - Body ground | Pressure sensor switch signal | Refrigerant pressure normal (0.19 MPa [2.0 kgf/cm2] to 3.14 MPa [32 kgf/cm2]) | 11 to 14 V |
| Refrigerant pressure abnormal (below 0.19 MPa [2.0 kgf/cm2] or more than 3.14 MPa [32 kgf/cm2]) | Below 1 V | |||
| J12-4 (ACT) - Body ground | GR - Body ground | Magnet clutch on permit signal | ·
Engine idling ·
Accelerator pedal: Released → Depressed |
11 to 14 V → Below 1 V |
| J12-5 (SG) - Body ground | L - Body ground | Ground for No. 1 cooler thermistor | Always | Below 1 Ω |
| J12-6 (TE) - J12-5 (SG) | Y - L | No. 1 cooler thermistor signal | Evaporator temperature
(ambient): 0°C (32°F) |
1.9 to 2.3 V |
| Evaporator temperature
(ambient): 15°C (59°F) |
1.1 to 1.5 V | |||
| J12-7 (IG+) - Body ground | Y - Body ground | IG power source | Ignition switch off → ON | Below 1 V → 11 to 14 V |
| J12-9 (A/C) - Body ground | L - Body ground | A/C switch signal | ·
Engine idling ·
Blower switch: LO ·
A/C switch: OFF → ON |
Below 1 V → 11 to 14 V |
| J12-10 (MGC) - Body ground | P - Body ground | Magnet clutch relay drive signal | ·
Engine idling ·
Blower switch: LO ·
A/C switch: OFF → ON (magnet clutch ON) |
11 to 14 V → Below 1 V |
| J12-11 (E) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| J12-12 (B/V) - Body ground | LG - Body ground | B/V signal | Evaporator temperature
(ambient): 0°C (32°F) |
2.0 to 2.4 V |
| Evaporator temperature
(ambient): 15°C (59°F) |
1.4 to 1.8 V |