CHECK BASIC OPERATION
Perform the check on flat ground.
Check the center door opening and closing operations.
Turn the automatic door cancel switch off.
Turn the ignition switch to ON.
When continuing to push the door control switch assembly towards OPEN, check that after the automatic door warning buzzer has sounded for 0.8 seconds, the center door operates until it is fully open.
While continuing to push the door control switch assembly towards OPEN, check that when the center door has been detected as being fully open, the automatic door warning buzzer sounds for 0.8 seconds.
When continuing to push the door control switch assembly towards CLOSE, check that after the automatic door warning buzzer has sounded for 0.8 seconds, the buzzer sounds intermittently, and the center door closes.
When continuing to push the door control switch assembly towards CLOSE, check that when the center door has been detected as being fully closed, the automatic door warning buzzer sounds for 0.8 seconds.
When the center door is opening or closing and the door control switch assembly is turned off, check that the center door movement stops, and that when the door control switch assembly is operated again, the center door starts opening or closing from the position where it was stopped previously.
Check the center door opening and closing prevention operations.
Check that the under the following conditions, the automatic door warning buzzer sounds when the door control switch assembly is operated, and that the center door does not open or close.
When the automatic door cancel switch is turned on.
When vehicle speed is above 3 km/h.
Center door opening and closing check when the emergency unlock switch is used.
Check that the center door opens while the emergency unlock switch is pushed.
Center door opening and closing check when operated manually.
Check that when 3 seconds or more have elapsed since the center door was detected as being fully closed, and vehicle speed is less than 3 km/h, the center door can be operated manually.
CHECK JAM PROTECTION FUNCTION
When checking, take extra care not to get your hands caught.
Check the center door jam protection function during opening operations.
Operate the door control switch assembly to open the center door.
While the center door is operating, and when the door is obstructed by hand (slowing down the operation of the door), check that the buzzer sounds twice, and that the center door moves in the opposite direction to its direction of travel (closing), and then stops.
Check the center door jam protection function during closing operation.
Operate the door control switch assembly to close the center door. While the center door is operating.
While the center door is operating, and when the door is obstructed by hand (slowing down the operation of the door), check that the buzzer sounds twice, and that the center door moves in the opposite direction to its direction of travel (opening), and then stops.