48818C
1.INSTALL REAR STABILIZER BUSH LH
Install the rear stabilizer bush LH so that the slit is facing the front of the vehicle.
| *a | Arrow |
| *b | Slit |
Install the rear stabilizer bracket cover so that the arrow is facing the front of the vehicle.
48818B
2.INSTALL REAR STABILIZER BUSH RH
Use the same procedures described for the LH side.
48812
3. TEMPORARILY INSTALL REAR STABILIZER BAR
Temporarily install the rear stabilizer bar with the 4 bolts.
48840A
4.INSTALL REAR STABILIZER LINK ASSEMBLY LH
Install the rear stabilizer link assembly LH with the 2 nuts.
76 N*m (775 kgf*cm, 56 ft.*lbf)
If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.
48830D
5.INSTALL REAR STABILIZER LINK ASSEMBLY RH
Use the same procedures described for the LH side.
48812
6.TIGHTEN REAR STABILIZER BAR
After tightening the 2 rear side bolts, tighten the 2 front side bolts.
45 N*m (459 kgf*cm, 33 ft.*lbf)