48210C
1.REPLACE EYE BUSHING
Using a press and socket wrench, replace the eye bushings.
2. BEND OPEN FRONT SPRING CLIP AND REMOVE REAR SPRING CLIP NUT AND BOLT
Using a chisel and hammer, pry up the front and rear spring clip.
3.REMOVE CENTER BOLT
Hold the spring near the center bolt in a vise and remove the center bolt.
4.INSTALL SPRING CENTER BOLT
Align the leaf holes and secure the leaves with a vise.
Install the spring center bolt.
50 N*m (510 kgf*cm, 37 ft.*lbf)
5. BEND FRONT SPRING CLIP AND INSTALL REAR SPRING CLIP BOLT AND NUT
Using a hammer, bend the front and rear spring clip into position.