48220
1.INSTALL REAR LEAF SPRING
Place the front end of leaf spring in the front bracket and install the hanger pin bolt.
Temporarily tighten the hanger pin nut.
Place the rear end of leaf spring in the rear bracket, and install the shackle pin.
Install the plate and temporarily tighten the 2 nuts.
2.INSTALL U-BOLTS
Install the pads and pad. retainer on the leaf spring.
Install the spring seat, U-bolts, washers and nuts.
Tighten the U-bolt mounting nut.
200 N*m (2,050 kgf*cm, 148 ft.*lbf)
Tighten the U-bolts so that the length of all the U-bolts under the spring seat are the same.
48540
3.INSTALL REAR SHOCK ABSORBER
Connect the rear shock absorber lower to the spring seat with the bolt.
Tighten the bolt.
70 N*m (700 kgf*cm, 52 ft.*lbf)
48840A
4.CONNECT STABILIZER BAR LINK (w/STABILIZER BAR)
Connect the left and right stabilizer ber links with the 2 nuts.
95 N*m (950 kgf*cm, 69 ft.*lbf)
If the ball joint stud turns together with the nut, use a hexagon wrench to hold the stud.
5. STABILIZE SUSPENSION
Lower the vehicle.
Bounce the vehicle up and down several times to allow the suspension to settle.
6. TIGHTEN HANGER PIN AND SHACKLE PIN
Tighten the hanger pin nut.
325 N*m (3,350 kgf*cm, 240 ft.*lbf)
Tighten the 2 shackle pin nuts.
225 N*m (2,300 kgf*cm, 165 ft.*lbf)
135 N*m (1,400 kgf*cm, 100 ft.*lbf)
Install the spring pin stopp'er with the bolt.