1.DISCONNECT BRAKE LINES
Using SST, disconnect the 5 brake lines from the ABS actuator.
10 mm Nut: 15 N*m (155 kgf*cm, 11 ft*lbf)
12 mm Nut: 24 N*m (245 kgf*cm, 18 ft*lbf)
2.DISCONNECT 2 CONNECTORS FROM ABS ACTUATOR
3.REMOVE ABS ACTUATOR ASSEMBLY
Remove the brake line mount bolt.
29 N*m (300 kgf*cm, 22 ft*lbf)
Remove the 4 nuts and actuator assembly.
39 N*m (400 kgt*cm, 29 ft*lbf)
4.REMOVE ABS ACTUATOR
Using SST, remove the 3 brake lines.
15 N*m (155 kgf*cm, 11 ff*lbf)
Remove the 2 bolts and 2-way.
8.8 N*m (90 kgf*cm, 78 in.*lbf)
Remove the bolt and connector clamp.
6.0 N*m (60 kgf*cm, 52 in.*lbf)
Remove the 4 nuts and actuator from the actuator bracket.
5.4 N*m (55 kgf*cm, 48 in.*lbf)
Remove the 4 holders and cushions from the ABS actuator.
Remove the 4 nuts and separate the bracket.
19 N*m (195 kgf*cm, 14 ft*lbf)