Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VSC OFF SWITCH (w/ VSC)
RM2850E _54 Brake _073264 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0358164 VSC OFF SWITCH(w/ VSC) G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VSC OFF SWITCH(w/ VSC)  INSPECTION  


PROCEDURE

Hide 1.INSPECT VEHICLE STABILITY CONTROL SWITCH (VSC OFF SWITCH)

a.
C403096E01
1.021,1.948 1.177,1.948 1.177,1.948 1.438,1.448 false 2.531,1.938 2.365,1.938 2.365,1.938 2.167,1.438 false 0.094,0.083 0.406,0.281 0.313,0.198 10 false *a 0.854,1.854 1.167,2.052 0.313,0.198 10 false + 2.615,1.865 2.927,2.063 0.313,0.198 10 false E

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
9 (+) - 6 (E) Pushed Below 1 Ω
Not pushed 10 kΩ or higher


Text in Illustration
*a Component without harness connected
Vehicle Stability Control Switch (VSC OFF switch)

If the result is not as specified, replace the vehicle stability control switch (VSC OFF switch).


b.
C403097E01
1.885,1.24 2.5,1.24 false 1.323,4.333 1.479,4.333 1.479,4.333 1.708,3.792 false 2.333,4.333 2.156,4.333 2.156,4.333 1.969,3.792 false 0.135,0.073 0.448,0.271 0.313,0.198 10 false *a 2.615,1.156 2.927,1.354 0.313,0.198 10 false *b 2.417,4.25 2.729,4.448 0.313,0.198 10 false ILL- 1.01,4.229 1.323,4.427 0.313,0.198 10 false ILL-

Check that the LED illuminates.

i.

Apply battery voltage between the terminals of the vehicle stability control switch (VSC OFF switch), and check the illumination condition.

OK:
Measurement Condition Switch Condition
Battery positive (+) →8 (ILL+)
Battery negative (-) → 7 (ILL-)
Illuminates


Text in Illustration
*a Component without harness connected
Vehicle Stability Control Switch (VSC OFF switch)
*b Indicator