Home › Engine / Hybrid System › 14B (ENGINE MECHANICAL) › CYLINDER HEAD › 2017.01–2019.08
RM2850E _51 Engine / Hybrid System _073170 14B ENGINE MECHANICAL _0356053 CYLINDER HEAD A

14B ENGINE MECHANICAL  CYLINDER HEAD  CYLINDER HEAD ASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Thoroughly clean all parts to be assembled.

·

Before installing the parts, apply fresh engine oil to all sliding and rotating surfaces.

·

Replace all gaskets and oil seals with new ones.



PROCEDURE

Hide 1.INSTALL COMBUSTION CHAMBERS (3B)

a.
A429031

Align the combustion chamber knock pin with the cylinder head notch.


b.

Using a plastic-faces hammer, tap in the combustion chamber.


c.
A429032

Using a dial indicator, check the combustion chamber protrusion.

Combustion chamber protrusion:

Minus 0.05 - Plus 0.05 mm (Minus 0.0020 - Plus 0.0020 in.)



Hide 2.INSTALL VALVES

a.

Place the spring seat on the cylinder head.


b.
A429033

Install new oil seals on the valve guide bushings.

HINT:

Pushing down at the places shown in the illustration.



c.

Rotate the oil seal to check that it is firmly installed.


d.

Install these parts:

·

Valve

·

Valve springs

·

Spring retainer



e.
A429034

Using SST, compress the valve springs and place the 2 keepers around the valve stem.

SST
09202-70020  (09202-00030)


f.
A429035

Using a plastic-faced hammer, lightly tap the valve stem tip to assure a proper fit.


g.

Install the valve stem cap.