Home › Engine / Hybrid System › 1BZ-FPE (ENGINE CONTROL) › ELECTRONIC CONTROLLED CARBURETOR SYSTEM › 2017.01–2021.01
RM2850E _51 Engine / Hybrid System _073136 1BZ-FPE ENGINE CONTROL _0355837 ELECTRONIC CONTROLLED CARBURETOR SYSTEM D

1BZ-FPE ENGINE CONTROL  ELECTRONIC CONTROLLED CARBURETOR SYSTEM  DTC CHECK / CLEAR  


CHECK THE CHECK ENGINE WARNING LIGHT


F102324

a.

The check engine warning (CHK ENG) comes on when the ignition switch is turned ON and the engine is not running.

HINT:

If the check engine warning (CHK ENG) does not light up, troubleshoot the combination meter.



b.

When the engine is started, the check engine warning light should go off. If the lamp remains on, the diagnosis system has detected a malfunction or abnormality in the system



CHECK THE DTC, USING HAND-HELD TESTER


NOTICE:

(Hand-held tester only): When the diagnosis system is switched from normal mode to check (test) mode, it erases all DTCs and freezed frame data recorded in normal mode.

So before switching modes, always check the DTCs and freezed frame data, and note them down.


a.

Prepare the hand-held tester.


b.

Connect the hand-held tester to DLC3.


c.

Turn the ignition switch ON and switch the hand-held tester main switch ON.


d.

Use the hand-held tester to check the DTCs and freezed frame data, note them down (For operating instructions, see the hand-held tester's instruction book.).




IF YOU HAVE NO HAND-HELD TESTER, PERFORM THE FOLLOWING STEP (1) TO (6)


a.
A420118

Turn the ignition switch ON.


b.

Using SST, connect between terminals 13 (TC) and 4 (CG) of DLC3.

SST
09843-18040  


c.
A420119

Read the DTC from the check engine warning light (CHK ENG).


d.
A421333

As an example, the blinking patterns for codes, normal, 12 and 31 are as shown on the illustration.


e.

f.

After completing the check, disconnect terminals 13 (TC) and 4 (CG) and turn off the display.

HINT:

In the event of 2 or more malfunction cords, indication will begin from the smaller numbered cord and continue in order to the larger.


NOTICE:

When simulatiing symptoms without a hand-held tester to check the DTCs, use normal mode. For codes on the DTCs, chart subject to "2 trip detection logic", turn the ignition switch OFF after the symptom is simulated the first time.

Then repeat the simulation process again. When the problem has been simulated twice, the check engine warning light Iights up and the DTCs, are recorded in the engine ECU.