Home › Engine / Hybrid System › 14B (ENGINE MECHANICAL) › TIMING GEAR › 2017.01–2019.08
RM2850E _51 Engine / Hybrid System _073170 14B ENGINE MECHANICAL _0356052 TIMING GEAR A

14B ENGINE MECHANICAL  TIMING GEAR  CRANKSHAFT FRONT OIL SEAL REPLACEMENT  


CAUTION / NOTICE / HINT

HINT:

There are 2 methods (A and B) to replace the oil seal as follows:


PROCEDURE

Hide 1.REPLACE CRANKSHAFT FRONT OIL SEAL

a.

If timing gear cover is removed from cylinder block:

i.
A430618

Using a screwdriver and hammer, tap out the oil seal.


ii.
A430619

Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing gear cover edge.

SST
09223-46011  


iii.

Apply MP grease to the oil seal lip.



b.

If timing gear cover is installed to the cylinder block:

i.
A430620

Using SST, and a socket wrench remove the oil seal.

SST
09308-10010  


ii.

Apply MP grease to a new oil seal lip.


iii.
A430621

Using SST and a hammer, tap in the oil seal until its surface is flush with the timing gear cover edge.

SST
09223-46011