Home › Engine / Hybrid System › 1BZ-FPE (FUEL) › LPG CARBURETOR › 2017.01–2021.01
RM2850E _51 Engine / Hybrid System _073202 1BZ-FPE FUEL _0356253 LPG CARBURETOR G

1BZ-FPE FUEL  LPG CARBURETOR  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

Use the engine conditioner for the carburetor.

·

Take care not to splash the engine conditioner on the rubber parts.

·

After cleaning, remove the engine conditioner thoroughly.



PROCEDURE

Hide 1.CLEAN LPG CARBURETOR BODY

a.

Spray the engine conditioner on the places listed below and wait for 1 to 5 minutes.

·

Around the throttle valve

·

Around the bore

·

Air bypass port

·

Air adjust screw

·

Fuel passage of the air fuel ratio control motor

·

Fuel passage of the injector



b.

With a waste cloth, wipe off the deposit dissolved by the engine conditioner.


c.

Using compressed air, remove the residue of the deposit and engine conditioner.

NOTICE:

This should be carried out for all the passages of the carburetor.



Hide 26280 2.CLEAN AIR FUEL RATIO CONTROL MOTOR

a.

With a waste cloth, wipe the deposit off the needle valve.


Hide 23260T 3.CLEAN INJECTOR

a.
A422060

With a waste cloth, wipe off the carbon around the nozzle.


b.

Applying compressed air of 343 - 490 kPa (3.5 - 5.0 kgf/cm2, 49.8 - 71.1 psi) from the fuel intake opening, insert wire with diameter of less than 1.2 mm (0.047 in.) into the nozzle and take it out. Repeat this 10 times.

NOTICE:

Insert the wire within the extent of 20 mm (0.79 in.).