Home › General › SPECIFICATIONS › 1HZ FUEL
RM2850E _V1 General _073185 SPECIFICATIONS _0366790 1HZ FUEL F

SPECIFICATIONS  1HZ FUEL  SERVICE DATA  


FUEL HEATER
Tester Connection Condition Specified Condition

*: Apply a vacuum of 350 +/- 50 mmHg (13.78 +/- 1.97 in.Hg, 46.7 +/- 6.7 kPa) or more to the vacuum switch port.

1 - Switch body 20°C (68°F) 0.5 to 2.0 Ω

INJECTION PRESSURE TEST
New nozzle Opening pressure 14,710 - 15,690 kPa (150 - 160 kgf/cm2, 2,133 - 2,276 psi)
Reused nozzle Opening pressure 14,220 - 15,200 kPa (145 - 155 kgf/cm2, 2,062 - 2,205 psi)
Adjusting opening pressure Opening pressure 14,220 - 15,690 kPa (145 - 160 kgf/cm2, 2,062 - 2,276 psi)

FUEL INJECTION PUMP
Plunger spring Maximum squareness 2.0 mm (0.079 in.)
Spring free length 30.0 mm (1.181 in.)
Delivery valve spring Spring free length 24.4 mm (0.961 in.)
Coupling spring Spring free length 16.6 mm (0.654 in.)
Pneumatic bellows spring (w/ HAC) Spring free length 35.0 mm (1.378 in.)
Roller ring and roller Roller height variation 0.02 mm (0.0008 in.)
Pickup sensor Resistance 600 - 800 Ω
Test nozzle and nozzle holder Test nozzle DN12SD12 (DENSO)
Test nozzle opening pressure 14,220 - 15,200 kPa (145 - 155 kgf/cm2, 2,062 - 2,205 psi)
Allowable error +/- 40 rpm
Governor shaft Protrusion 0.3 - 2.0 mm (0.020 - 0.079 in.)
Adjust cold starting system (w/ ACSD) Fuel temperature 24 - 26 °C (75 - 79 °F)
Adjust cold starting system Fuel temperature 15 - 35 °C (59 - 96 °F)
Post adjustment Pump revolution 100 rpm
q = 1.5 cc (0.09 cu in.) or less
Adjusting lever angle 38 - 48°
Preset timer adjusting screw Protrusion 7.5 - 8.0 mm (0.295 - 0,315 in.)
Flyweight holderthrust clearance Thrust clearance 0.15 - 0.35 mm (0.0059 - 0.0138 in.)
Adjust plunger pre-stroke Pre-stroke 0.15 - 0.25 mm (0.0059 - 0.0098 in.)
Dimension B 2.8 - 3.2 mm (0.110 - 0.126 in.)
Adjust timer Timer spring free length 32.0 mm (1.260 In.)

FUEL SENDER GAUGE ASSEMBLY (for Double Tank Type)
Tester Connection Condition Specified Condition

*: The output voltage changes depending on the voltage applied to the terminals.

2 - 3 Float position is F (upper) 4.255 to 4.605 V*
Float position is E (lower) 0.345 to 0.695 V*