Home › General › SPECIFICATIONS › 1HZ CHARGING
RM2850E _V1 General _073185 SPECIFICATIONS _0366795 1HZ CHARGING F

SPECIFICATIONS  1HZ CHARGING  TORQUE SPECIFICATIONS  


CHARGING SYSTEM
Part tightened N*m kgf*cm ft.*lbf
Battery x Battery terminal 5.4 55 48 in.*lbf

GENERATOR
Part tightened N*m kgf*cm ft.*lbf
Retainer plate x Generator drive end frame 2.3 23 20 in.*lbf
Generator coil assembly x Generator drive end frame 5.9 60 52 in.*lbf
Generator brush holder assembly x Generator coil assembly 1.8 18 16 in.*lbf
Rear generator end cover x Generator coil assembly 4.6 47 41 in.*lbf
Generator pulley x Generator rotor assembly 133 1356 98
Generator assembly x Engine for bolt A 79 806 58
for bolt B 64 650 47
Generator wire x Tarminal B 9.8 100 87 in.*lbf
Front engine service cover panel sub-assembly x Body 8.0 82 71 in.*lbf
Shift wire clamp x Front engine service cover panel sub-assembly 12 122 9
Floor shift control shift lever retainer sub-assembly x Front engine service cover panel sub-assembly for bolt A 7.5 76 66 in.*lbf
for bolt B 12 122 9
Shift and select lever support with boots x Floor shift control shift lever retainer sub-assembly 8.0 82 71 in.*lbf