Home › General › SPECIFICATIONS › 2TR-FE STARTING
RM2850E _V1 General _073185 SPECIFICATIONS _0367038 2TR-FE STARTING F

SPECIFICATIONS  2TR-FE STARTING  SERVICE DATA  


STARTER
Starter assembly Specified current 90 A or less at 11.5 V
Starter armature Segments Standard resistance 1 Ω
Commutator-Armature coil Standard resistance 10 kΩ or higher
Commutator circle runout Maximum runout 0.05 mm (0.002 in.)
Commutator diameter Standard diameter 30.0 mm (1.181 in.)
Minimum diameter 29.0 mm (1.141 in.)
Commutator undercut depth Standard undercut depth 0.6 mm (0.024 in.)
Minimum undercut depth 0.2 mm (0.008 in.)
Starter yoke assembly Lead wire - brush Standard resistance Below 1 Ω
Starter brush holder Brush length Standard length 15.5 mm (0.610 in.)
Minimum length 10.0 mm (0.394 in.)
Spring load Standard spring load 17.6 to 23..5 N (1.8 to 2.4 kgf, 4.0 to 5.3 lbf)
Minimum spring load 11.8 N (1.2 kgf, 2.7)
Positive brush holder and negative brush holder Standard resistance 10 kΩ or higher
Magnetic switch Terminal 50 - C Standard resistance Below 1 Ω
Terminal 50 - Switch body Standard resistance Below 2 Ω

STARTER RELAY
Item Tester Connection Switch Condition Specified Condition
Starter relay assembly 3 - 5 Battery voltage applied to terminals 1 and 2 Below 1 Ω
Battery voltage not applied to terminals 1 and 2 10 kΩ or higher

IGNITION SWITCH
Item Switch Condition Specified Condition
Between all terminals LOCK 10 kΩ or higher
4 (ACC) - 6 (AM1) ACC Below 1 Ω
4 (ACC) - 6 (AM1) ON Below 1 Ω
5 (IG1) - 6 (AM1)
11 (IG2) - 12 (AM2)
5 (IG1) - 6 (AM1) START Below 1 Ω
3 (ST1) - 6 (AM1)
11 (IG2) - 12 (AM2)
9 (ST2) - 12 (AM2)