Home › General › SPECIFICATIONS › 2TR-FE CHARGING
RM2850E _V1 General _073185 SPECIFICATIONS _0367039 2TR-FE CHARGING F

SPECIFICATIONS  2TR-FE CHARGING  TORQUE SPECIFICATIONS  


GENERATOR (for 80A Type)
Part Tightened N*m kgf*cm ft.*lbf
Retainer plate x Generator drive end frame 2.3 23 20 in.*lbf
Generator coil assembly x Generator drive end frame 5.6 57 50 in.*lbf
Generator brush holder assembly x Generator coil assembly 1.8 18 16 in.*lbf
Rear generator end cover x Generator coil assembly 4.6 47 41 in.*lbf
SST 1-A x SST 1-B 3.9 398 29 in.*lbf
Generator with clutch pulley x Generator rotor assembly 133 1356 98
Generator assembly x Engine assembly 43 439 32
Terminal B x Generator assembly 9.8 100 87 in.*lbf
Front engine service cover panel sub-assembly x Body for bolt 8.0 82 71 in.*lbf
for nut 12 122 9
Floor shift control shift lever retainer sub-assembly x Body for bolt A 7.5 76 66 in.*lbf
for bolt B 12 122 9
Shift and select lever support with boots x Body 8.0 82 71 in.*lbf

GENERATOR (for 100A Type)
Part Tightened N*m kgf*cm ft.*lbf
Retainer plate x Generator drive end frame 2.3 23 20 in.*lbf
Generator coil assembly x Generator drive end frame 5.6 57 50 in.*lbf
Generator brush holder assembly x Generator coil assembly 1.8 18 16 in.*lbf
Rear generator end cover x Generator coil assembly 4.6 47 41 in.*lbf
Generator with clutch pulley x Generator rotor assembly 80 (64) 816 (653) 59 (47)
Generator assembly x Engine assembly 43 439 32
Terminal B x Generator assembly 9.8 100 87 in.*lbf

( ): For use with SST