Home › General › SPECIFICATIONS › N04C-UH LUBRICATION › 2017.01–2021.01
RM2850E _V1 General _073185 SPECIFICATIONS _0367209 N04C-UH LUBRICATION F

SPECIFICATIONS  N04C-UH LUBRICATION  SERVICE DATA  


LUBRICATION SYSTEM
Oil pressure When idling 190 kPa (1.9 kgf/cm2, 27.6 psi)

OIL PRESSURE SWITCH
Resistance (Terminal 1 - Body ground) Engine stopped Below 1 Ω
Engine idling 10 kΩ or higher

OIL LEVEL SENSOR
Resistance (Terminal 1 - 2) Float at bottom 10 kΩ or higher
Float at top Below 1 Ω

OIL PUMP
Oil pump assembly Standard backlash (for oil pump gear) 0.065 to 0.215 mm (0.0026 to 0.0084 in.)
Maximum backlash (for oil pump gear) 0.3 mm (0.0118 in.)
Standard width 27.02 to 27.04 mm (1.0638 to 1.0645 in.)
Standard depth 27.03 to 27.07 mm (1.0642 to 1.0657 in.)
Standard clearance 0.05 to 0.13 mm (0.00197 to 0.00512 in.)
Maximum clearance 0.17 mm (0.0067 in.)
Standard backlash (for drive gear) 0.091 to 0.217 mm (0.00358 to 0.00854 in.)
Maximum backlash (for drive gear) 0.25 mm (0.00984 in.)
Standard shaft diameter (for drive gear shaft) 18.088 to 18.106 mm (0.7121 to 0.7128 in.)
Standard bush inside diameter (for drive gear bush) 18.146 to 18.187 mm (0.7144 to 0.7155 in.)
Standard clearance 0.040 to 0.085 mm (0.0016 to 0.00335 in.)
Maximum clearance 0.10 mm (0.00394 in.)
Standard shaft diameter (for driven gear shaft) 17.979 to 17.997 mm (0.7078 to 0.7085 in.)
Standard bush inside diameter (for driven gear bush 18.037 to 18.054 mm (0.7101 to 0.7108 in.)
Standard clearance 0.040 to 0.075 mm (0.00157 to 0.00295 in.)
Maximum clearance 0.13 mm (0.0051 in.)