Home › General › SPECIFICATIONS › 1BZ-FPE FUEL
RM2850E _V1 General _073185 SPECIFICATIONS _0368669 1BZ-FPE FUEL F

SPECIFICATIONS  1BZ-FPE FUEL  SERVICE DATA  


LPG regulator Primary pressure STD 28.5 - 34.3 kPa (0.29 - 0.35 kgf/cm2 , 4.1 - 5.0 psi)
First lever height 10.7 - 11.3 mm (0.421 - 0.445 in.)
Primary pressure adjusting screw height 12 - 19 mm (0.47 - 0.75 in.)
First valve airtightness Remain 58.8 - 78.4 kPa (0.6 - 0.8 kgf/cm2 , 8.5 - 11.4 psi)
Second lever height No leakage for 1 minute
LPG solenoid valve Resistance at 20°C (68°F) 8.5 - 10.5Ω
Fuel cut solenoid valve Resistance at 20°C (68°F) 20.5 - 24.5Ω
Injector Resistance at 20°C (68°F) 3.5 - 4.5Ω
Air fuel ratio control motor Height at engine stopped 13 - 14 mm (0.51 - 0.55 in.)
at the idle speed 14 - 18 mm (0.55 - 0.71 in.)
Throttle position sensor Resistance between terminals 1 and 4 2.5 - 11.5kΩ
Resistance between terminals 3 and 2 Throttle valve full close 0.5 - 5.9kΩ
Throttle valve full open 2.3 - 10kΩ
Solenoid resistor Resistance at 20°C (68°F) 5.7 - 6.3Ω
Vacuum sensor Voltage VCC - E2 4.5 - 5.5V
PIM - E2 4.5 - 5.5V
Vacuum hose disconnected 3.3 - 3.9V
Apply vacuum 67 kPa (500mm Hg, 19.69in. Hg) 1.3 - 1.9V