Home › Drivetrain › A861E (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSMISSION SYSTEM › from 2019.08
RM2850E _52 Drivetrain _082622 A861E AUTOMATIC TRANSMISSION / TRANSAXLE _0398655 AUTOMATIC TRANSMISSION SYSTEM D

A861E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM  ROAD TEST  


PROBLEM SYMPTOM CONFIRMATION


a.

Based on the result of the customer problem analysis, try to reproduce the symptoms. If the problem is that the transmission does not shift up, shift down, or the shift point is too high or too low, conduct the following road test referring to the automatic shift schedule and simulate the problem symptoms.



ROAD TEST


CAUTION:
·
A371909

Strictly obey all traffic rules and regulations.

·

Do not drive the vehicle with the GTS cable contacting the pedals, shift lever or steering wheel.

·

Driving the wheel with the GTS cable contacting these areas could impede vehicle control, resulting in a serious accident.


·
A356953

Do not operate the GTS while driving the vehicle.

·

Operating the GTS while driving the vehicle will prevent you from paying sufficient attention to vehicle surroundings, and could result in a serious accident.



NOTICE:
·

Be sure to inspect and adjust the engine before performing these tests.

·

Perform the road test with the ATF temperature between 50 and 80°C (122 and 176°F).

·

Perform these tests with the air conditioning off.



Inspection Procedure
D Position Shift Test While driving the vehicle normally, check that the transmission shifts up and down through each gear properly.
Shift Shock Level while Driving with Shift Lever in D While driving the vehicle normally, check the shock level for each upshift operation.
Transmission Control Switch (O/D Switch) Test In the 6th gear speed range, operate the O/D switch between on and off and check that the gear changes between 6th gear and 5th gear.
No. 1 Pattern Select Switch Assembly (First Hold Switch) Test
·

After the engine stops, check that first hold is released when the ignition switch is turned to ON or when the shift lever is moved to a position other than 2/L.

·

With the shift lever in 2/L, operate the pattern select switch between on and off and check that the gear changes between 2nd gear and 1st gear.


Kick-down Function
·

Perform the kick-down operation at each gear and check that the vehicle downshifts.

·

Check the shock level during kick-down.


Engine Brake Test
·

While driving (at a vehicle speed of approximately 55 to 65 km/h) with the shift lever in D (5th gear), move the shift lever from D to 4 and check engine braking at the 4th gear.

·

While driving (at a vehicle speed of approximately 30 to 40 km/h) with the shift lever in 4 (4th gear), move the shift lever from 4 to 2/L and check engine braking at the 2nd gear.


Speed Variation Point with Accelerator Pedal Fully Depressed With the shift lever in D, start off with the accelerator pedal fully depressed and check that the upshift rate from 1st gear to 2nd gear conforms to the speed variation point.
Lock-up Function While driving on a level surface at a constant speed in the lock-up range with the shift lever in D, lightly depress the accelerator pedal and check that the engine speed does not change abruptly.
P Position Test Stop the vehicle on an incline (approximately 5° or more). Then move the shift lever to P and release the parking brake. Check that the parking lock pawl holds the vehicle in place.
Abnormal Noise and Vibration Check for abnormal noise and vibration while driving the vehicle forward and backward, and during shift operations.
Fluid Leakage After performing all other road test inspections, check for fluid leakage.

HINT:

When checking for DTCs after a repair, drive the vehicle according to the monitor drive pattern.

Click hereDrivetrain>A861E (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM>MONITOR DRIVE PATTERN


a.

Gear change confirmation

i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the GTS on.


iv.

Enter the following menus: Powertrain / ECT / Data List / Vehicle Speed, SPD (NT), A/T Oil Temperature 1, Shift Status.


v.

Check that the transmission shifts to each gear while gently accelerating to 80 km/h (50 mph) or higher.

HINT:
·

Check that the value of "SPD (NT)" drops by 50 rpm or more when the value of "Shift Status" increases.

·

Depending on the engine speed when the gear is changed, it may be difficult to see the change of "SPD (NT)".





b.

Lock-up confirmation

i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the GTS on.


iv.

Enter the following menus: Powertrain / ECT / Data List / Vehicle Speed, Engine Speed, Throttle Sensor Volt %, SPD (NT), A/T Oil Temperature 1, Lock Up, Shift Status.


v.

When the following conditions are met, check that the difference between "Engine Speed" and "SPD (NT)" is 50 rpm or less.

Lock-up Schedule
Vehicle Speed 80 km/h (50 mph) or more
Shift Status 6th gear
Lock Up ON

HINT:

Lock-up prohibition conditions:

·

A/T oil temperature is below 25°C (77°F)

·

Shift lever in 2/L

·

Throttle valve opening angle is fully closed

·

Stop light switch is on