STALL SPEED TEST
Do not perform a stall test if there are any people or objects near the vehicle.
The vehicle could begin moving suddenly, resulting in a serious accident.
Do not perform a stall test if any wheel chocks are out of position.
The vehicle could begin moving suddenly, resulting in a serious accident.
Do not perform the stall test on a slippery or low-friction surface that could allow the tires to spin.
The vehicle could begin moving suddenly, resulting in a serious accident.
Do not perform the stall speed test for more than 5 seconds.
When performing the stall speed test more than once, make sure to wait 15 seconds or more between tests.
Perform the test at the normal operating ATF temperature of 50 to 80°C (122 to 176°F).
This test is to check the overall performance of the engine and transmission.
Run the vehicle until the ATF temperature has reached 50 to 80°C (122 to 176°F).
Allow the engine to idle with the air conditioning off.
Chock all 4 wheels.
Set the parking brake and keep the brake pedal depressed firmly with your left foot.
Move the shift lever to the drive position.
Depress the accelerator pedal as much as possible with your right foot.
Read the engine speed (stall speed) and release the accelerator pedal immediately.
1900 +/-150 rpm
SHIFT TIME LAG TEST
When the shift lever is moved while the engine is idling, there will be a certain time lapse or lag before the shock can be felt. This is used for checking the condition of the clutch, and brake.
Perform the test at the normal operating ATF temperature of 50 to 80°C (122 to 176°F).
Run the vehicle until the ATF temperature has reached 50 to 80°C (122 to 176°F).
Allow the engine to idle with the air conditioning off.
Set the parking brake and keep the brake pedal depressed firmly.
Check the D range time lag.
Move the shift lever to N and wait for 1 minute.
Move the shift lever to D and measure the time until the shock is felt.
Repeat the 2 procedures above 3 times, and calculate the average time of the 3 tests.
D range time lag is less than 0.7 seconds
Check the R range time lag.
Move the shift lever to N and wait for 1 minute.
Move the shift lever to R and measure the time until the shock is felt.
Repeat the 2 procedures above 3 times, and calculate the average time of the 3 tests.
R range time lag is less than 1.2 seconds