Home › Drivetrain › A861E (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSMISSION SYSTEM › from 2019.08
RM2850E _52 Drivetrain _082622 A861E AUTOMATIC TRANSMISSION / TRANSAXLE _0398655 AUTOMATIC TRANSMISSION SYSTEM D

A861E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM  HYDRAULIC TEST  


PERFORM HYDRAULIC TEST


CAUTION:
·
C328184


·

Do not perform a stall test if there are any people or objects near the vehicle.

·

The vehicle could begin moving suddenly, resulting in a serious accident.


·
C328186


·

Do not perform a stall test if any wheel chocks are out of position.

·

The vehicle could begin moving suddenly, resulting in a serious accident.


·
C328185


·

Do not perform the stall test on a slippery or low-friction surface that could allow the tires to spin.

·

The vehicle could begin moving suddenly, resulting in a serious accident.



NOTICE:
·

Perform the test at the normal operating ATF temperature of 50 to 80°C (122 to 176°F).

·

Be careful to prevent SST hose from interfering with the exhaust pipe.

·

This check must be conducted after checking and adjusting the engine.

·

Perform the test with the A/C turned off.

·

Do not perform the stall speed test for more than 5 seconds.

·

When performing the stall speed test more than once, make sure to wait 15 seconds or more between tests.



a.

Measure the line pressure.

i.

Warm up the ATF (Automatic Transmission Fluid).


ii.

Turn the ignition switch off.


iii.

Lift the vehicle up.


iv.
C419653C01
2.177,0.99 2.49,1.188 0.313,0.198 10 false *1
*1 Adapter


Remove the test plug on the transmission case front left side and connect SST.

Torque:

27 N*m (275 kgf*cm, 20 ft.*lbf)



v.

Lower the vehicle.


vi.

Fully apply the parking brake and chock the 4 wheels.


vii.

Start the engine and check the idling speed.


viii.

Keep your left foot pressed firmly on the brake pedal and move the shift lever to D.


ix.

Measure the line pressure when the engine is idling.


x.

Fully depress the accelerator pedal with your right foot. Quickly read the highest line pressure when the engine speed reaches the stall speed.


xi.

In the same manner, perform the test with the shift lever in R.

Specified Line Pressure:
Condition D Position kPa (kgf/cm2, psi) R Position kPa (kgf/cm2, psi)
Idling 560 to 870 kPa
(5.7 to 8.8 kgf/cm2, 81 to 126 psi)
560 to 870 kPa
(5.7 to 8.8 kgf/cm2, 81 to 126 psi)
Stall speed 1660 to 2010 kPa
(16.9 to 20.5 kgf/cm2, 241 to 291 psi)
1660 to 2010 kPa
(16.9 to 20.5 kgf/cm2, 241 to 291 psi)