DESCRIPTION
The automatic transmission has built-in diagnostic functions. If a malfunction occurs in the system, the transmission control ECU assembly stores the trouble code in the memory and the O/D OFF indicator light blinks to inform the driver. The DTC stored in the memory can be read out by the following procedure.
When the diagnostic trouble code is displayed, it is necessary to check whether the malfunction is only in the past or still continuing, and then check the relation to the reproduced malfunction. For this reason, it is required to display the diagnosis code twice, before and after the malfunction symptom check.
To check the DTCs, connect the GTS to the DLC3 on the vehicle. The GTS also enables you to erase the DTCs.
2 TRIP DETECTION LOGIC
When a malfunction is first detected, the malfunction is temporarily stored in the transmission control ECU assembly memory (1st trip). If the same malfunction is detected during the next drive cycle, the O/D OFF indicator light is blinks (2nd trip).
CHECK DATA LINK CONNECTOR 3 (DLC3)
Check the DLC3.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>GENERAL INFORMATION