Home › Drivetrain › A861E (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSMISSION FLUID › from 2019.08
RM2850E _52 Drivetrain _082622 A861E AUTOMATIC TRANSMISSION / TRANSAXLE _0398776 AUTOMATIC TRANSMISSION FLUID G

A861E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION FLUID  INSPECTION  


PROCEDURE

Hide 1.INSPECT AUTOMATIC TRANSMISSION FLUID LEVEL

NOTICE:
·

An excess or lack of automatic transmission fluid may cause problems.

·

Park the vehicle on a level surface.

·

After checking the idling speed, check the automatic transmission fluid level.

·

Check with the automatic transmission assembly fully warmed up (ATF temperature is 70 to 80°C (158 to 176°F)).

·

Use Toyota Genuine ATF type T-IV.



a.

Apply the parking brake.


b.

Depress the brake pedal and start the engine.


c.

While idling the engine, slowly move the shift lever through each shift position from P to 2/L, and then return the shift lever to P.


d.
C073478

While idling the engine, remove the level gauge, wipe it clean with a cloth, reinsert it and check that the automatic transmission fluid is in the "HOT" range.

NOTICE:
·

If the automatic transmission fluid temperature is low (20 to 30°C (68 to 86°F)) when replacing the automatic transmission fluid, etc., adjust the level gauge to the "COOL" range, and then fully warm up the automatic transmission assembly and check the automatic transmission fluid level again.

·

If the levels on the front and back of the level gauge differ, use the lowest level for the check.




e.

When the automatic transmission fluid level is low, check for leaks.