Home › Drivetrain › A861E (AUTOMATIC TRANSMISSION / TRANSAXLE) › PARK / NEUTRAL POSITION SWITCH › from 2019.08
RM2850E _52 Drivetrain _082622 A861E AUTOMATIC TRANSMISSION / TRANSAXLE _0398780 PARK / NEUTRAL POSITION SWITCH N

A861E AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  ADJUSTMENT  


PROCEDURE

Hide 84540 1.ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.
C398611C01
3,0.667 3.135,0.667 3.135,0.667 3.135,1.083 true 1.125,2.667 1.125,3 1.125,3 1,3 true 2.042,2.583 1.833,3.083 1.833,3.083 1.667,3.083 true 0.5,1.833 0.667,1.833 0.667,1.833 0.938,1.469 true 0.25,1.417 0.417,1.417 0.417,1.417 0.667,1.135 true 0.75,1 1.083,0.667 1.083,0.667 1.167,0.667 true 2.792,0.583 2.958,0.75 0.167,0.167 10 false *1 1.458,3 1.625,3.167 0.167,0.167 10 false *2 0.292,1.75 0.458,1.917 0.167,0.167 10 false *a 1.208,0.583 1.375,0.75 0.167,0.167 10 false *b 0.042,1.333 0.208,1.5 0.167,0.167 10 false *c 0.792,2.917 0.958,3.083 0.167,0.167 10 false *1 0.438,0.458 0.604,0.625 0.167,0.167 10 false A
*1 Set Bolt
*2 Manual Shaft
*a Neutral Standard Groove
*b Straightedge
*c Thickness Gauge


Move the shift lever to N.


b.

Loosen the 2 set bolts of the park/neutral position switch assembly.


c.

Align the center of the width-across-flats of the flat surface of the manual shaft with the center of the neutral standard groove.


d.

Set a straightedge against the side of the manual shaft and insert a 2.0 mm thickness gauge into the neutral standard groove.


e.

Set the straightedge on top of the neutral standard groove, and then using the thickness gauge, align the thickness gauge and dimension A to 2.0 mm and tighten the 2 set bolts.

Torque:
12.5 N*m (127 kgf*cm, 9 ft.*lbf)


f.

After adjustment, check the park/neutral position switch assembly.