32000
1.INSPECT TORQUE CONVERTER ASSEMBLY
Inspect the one-way clutch.
| *1 | Stopper |
| *2 | Tool |
Install SST (Tool) so that it fits in the notch of the converter hub and the outer race of the one-way clutch.
Install SST (Stopper) from the sleeve of torque converter assembly and engage the serration of the stator thrust washer.
Stand up the torque converter and turn SST (tool).
Check if it rotates smoothly when turned clockwise and locks up when turned counterclockwise.
| *a | Sample showing maximum allowable amount of powder in ATF |
Inspect the torque converter assembly.
If any of the following problems are present, replace the torque converter assembly.
A metallic sound is emitted from the torque converter assembly during the stall test or when the shift lever is moved to N.
The one-way clutch turns smoothly or locks in both directions.
The amount of powder in the ATF is more than the sample shown in the illustration (refer to the sample).
The sample shows approximately 0.025 liters (0.026 US qts, 0.022 Imp. qts) of ATF that was removed from a torque converter.
Replace the ATF in the torque converter.
If the ATF is discolored or has a foul odor, stir the ATF in the torque converter before replacing the ATF.
Check the torque converter installation bolts.
All of the installation bolts must be the same length (+/- 0.5 mm (0.0197 in.)) and each must have a spring washer.
2.INSPECT DRIVE PLATE
|
Measurement Point |
Check the drive plate for damage.
Set up a dial indicator and measure the runout at the 6 areas on the drive plate surface that contact the torque converter.
0.30 mm (0.0118 in.)
If the runout is more than the maximum or the drive plate is damaged, replace the drive plate.
Click hereEngine / Hybrid System>N04C-WA (ENGINE MECHANICAL)>REAR CRANKSHAFT OIL SEAL>INSTALLATION