Home › Drivetrain › A861E (AUTOMATIC TRANSMISSION / TRANSAXLE) › PATTERN SELECT SWITCH › from 2019.08
RM2850E _52 Drivetrain _082622 A861E AUTOMATIC TRANSMISSION / TRANSAXLE _0399388 PATTERN SELECT SWITCH G

A861E AUTOMATIC TRANSMISSION / TRANSAXLE  PATTERN SELECT SWITCH  INSPECTION  


PROCEDURE

Hide 84720A 1.INSPECT NO. 1 PATTERN SELECT SWITCH ASSEMBLY (FIRST HOLD SWITCH)

a.
C373042C02
1.219,1.677 1.448,1.271 true 2.198,1.656 1.99,1.26 true 1.823,1.156 2.135,0.521 true 1.615,1.135 1.26,0.531 true 0.167,0.135 0.479,0.333 0.313,0.198 10 false *a 1.042,1.698 1.5,1.896 0.458,0.198 10 false HOLD 2.229,1.688 2.542,1.885 0.313,0.198 10 false E 2.156,0.375 2.469,0.573 0.313,0.198 10 false ILL- 1.083,0.365 1.396,0.563 0.313,0.198 10 false ILL+
*a Component without harness connected
(No. 1 Pattern Select Switch Assembly (First Hold Switch))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
6 (HOLD) - 3 (E) First hold switch on
(Pressed)
Below 1 Ω
First hold switch off
(Relearsed)
10 kΩ or higher


If the result is not as specified, replace the No. 1 pattern select switch assembly (first hold switch).


b.

Apply battery voltage between the terminals of the No. 1 pattern select switch assembly (first hold switch), and check the illumination condition of the No. 1 pattern select switch assembly (first hold switch).

OK:
Measurement Condition Specified Condition
Battery positive (+) → 5 (ILL+) Battery negative (-) → 4 (ILL-) Illuminates


If the result is not as specified, replace the No 1 pattern select switch assembly (first hold switch).