Home › Engine / Hybrid System › N04C-WA (ENGINE CONTROL) › ECD SYSTEM › from 2019.08
RM2850E _51 Engine / Hybrid System _082611 N04C-WA ENGINE CONTROL _0399963 ECD SYSTEM C

N04C-WA ENGINE CONTROL  ECD SYSTEM  P2162  Vehicle Speed Sensor "A"/"B" Correlation  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P2162 Vehicle Speed Sensor "A"/"B" Correlation Diagnosis Condition:
·

Ignition switch ON.

·

Battery voltage is in the range of 10 V to 16 V


Malfunction Status:
The conditions described below remain for 5 seconds or longer.

Vehicle speed signal higher than 251 km/h (156 mph) continuing for at least 3 seconds is detected from the translate ECU assmbly by the CAN line.


Malfunction Duration:

3 seconds or more


Translate ECU assmbly Class C DTC stored

MONITOR DESCRIPTION

·

The ECM consistently measures pulses from the vehicle speed sensor through combination meter assembly.

·

The translate ECU assmbly also receives and measures the vehicle speed sensor signal from the combination meter assembly with the CAN communication line. The ECM uses the speed sensor signal from the translate ECU assmbly as backup when the malfunction occurs in the speed sensor signal line between the ECM and the combination meter assembly.


CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
P2162 Ignition switch ON for 3 seconds or more.


CAUTION / NOTICE / HINT

HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


PROCEDURE

1.CHECK COMBINATION METER ASSEMBLY
a.

Drive the vehicle and confirm that the combination meter (speedometer) is working properly.


Result:
Proceed to
OK
NG



OK

2.CHECK DTC OUTPUT

NG

REPAIR OR REPLACE COMBINATION METER ASSEMBLY

2.CHECK DTC OUTPUT
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS on.


c.

Clear the DTCs.

HINT:

Clear the DTCs with the engine stopped, as DTCs cannot be cleared while the engine is running.



d.

Turn the ignition switch off for 30 seconds or more.


e.

Perform the confirmation driving pattern.


f.

Turn the GTS on.


g.

Enter the following menus: Powertrain / Engine / Trouble Codes.


h.

Read Current DTCs.

Result:
Result Proceed to
DTC P2162 is output A
DTCs are not output B




A

B

END