Home › Engine / Hybrid System › N04C-WA (ENGINE CONTROL) › ECD SYSTEM › from 2019.08
RM2850E _51 Engine / Hybrid System _082611 N04C-WA ENGINE CONTROL _0399963 ECD SYSTEM C

N04C-WA ENGINE CONTROL  ECD SYSTEM  P226C  Turbocharger Boost Control "A" Slow Response  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P226C Turbocharger Boost Control "A" Slow Response Diagnosis Condition:

4 seconds after the read opening changes by 47% or more.


Malfunction Status:

A divergence of 10% or more continues between the read opening and actual opening for 200 msec or more.


Malfunction Duration:

200 msec or more


·

Turbocharger sub-assembly

·

Harness or connector


Class C DTC stored

MONITOR DESCRIPTION

·

The VNT actuator steplessly moves the nozzle vane via the LEA (Linear Electric Actuator) and controls turbocharger speed and boost pressure.

·

The sensor inside the LEA detects the amount of actuator movement and constantly monitors the nozzle vane target opening and actual opening.


CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
P226C
·

Idle the engine for 5 seconds or more after warming up the engine.

·

60 seconds or more with the engine speed at 450 rpm or higher



CAUTION / NOTICE / HINT

HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


PROCEDURE

1.PERFORM ACTIVE TEST USING GTS (CONTROL THE VN TURBO POSITION)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine / Active Test / Control the VN Turbo Position / Data List / Target VN Turbo Position / Actual VN Turbo Position.


e.

Inspect the response delay at each step of the Target VN Turbo position and Actual VN Turbo position from 90 to 0%.

NOTICE:

Perform the inspection while the engine is stopped to avoid engine damages.


Standard:

The response delay should be less than 3 seconds.


Result:
Proceed to
OK
NG




OK

2.CHECK DTC OUTPUT

NG

REPLACE TURBOCHARGER SUB-ASSEMBLY

2.CHECK DTC OUTPUT
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS on.


c.

Clear the DTCs.

HINT:

Clear the DTCs with the engine stopped, as DTCs cannot be cleared while the engine is running.



d.

Turn the ignition switch off for 30 seconds or more.


e.

Perform the confirmation driving pattern.


f.

Turn the GTS on.


g.

Enter the following menus: Powertrain / Engine / Trouble Codes.


h.

Read Current DTCs.

Result:
Result Proceed to
DTC P226C is not output A
DTCs P226C is output B




A

END

B

REPLACE TURBOCHARGER SUB-ASSEMBLY