Home › Engine / Hybrid System › N04C-WA (ENGINE CONTROL) › ECD SYSTEM › from 2019.08
RM2850E _51 Engine / Hybrid System _082611 N04C-WA ENGINE CONTROL _0399963 ECD SYSTEM C

N04C-WA ENGINE CONTROL  ECD SYSTEM  P204F  Reductant System Performance Bank 1  P205F  Reductant System Performance Bank 2  P20FE  Reductant Metering Unit 1 Performance  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P204F Reductant System Performance Bank 1 Diagnosis Condition:

-


Malfunction Status:

A malfunction detection is received from the DCU (emission control ECU assembly).


Urea SCR system Class varies according to DCU DTCs DTC stored
P205F Reductant System Performance Bank 2 Diagnosis Condition:

-


Malfunction Status:

A malfunction detection is received from the DCU (emission control ECU assembly).


Urea SCR system Class varies according to DCU DTCs DTC stored
P20FE Reductant Metering Unit 1 Performance Diagnosis Condition:

-


Malfunction Status:

A malfunction detection is received from the DCU (emission control ECU assembly).


Urea SCR system Class varies according to DCU DTCs DTC stored

MONITOR RESULT

·

Urea SCR system failures are diagnosed with the DCU (Dosing Control Unit).

·

Determine system in the DCU and diagnose malfunction with GTS .


CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
P204F
P205F
P20FE
Varies according to DCU DTCs


CAUTION / NOTICE / HINT

HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


PROCEDURE

1.CHECK DTC OUTPUT
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine / Trouble Codes.


e.

Read the DTCs.

Result:
Result Proceed to
DTC P204F,P205F and/or P20FE is output A
DTC P204F,P205F and/or P20FE is not output B


HINT:

In case the DTC P204F,P205F and/or P20FE has being recorded in the ECM, but no DTC has been detected in the DCU, it is safe to think that power supply to the DCU was interrupted before the DTC was recorded into the DCU.

In that case, please check for corrosion or abnormalities on the battery terminal.

If there is abnormality, clean or replace the battery terminal, and after deleting past DTC please verify again if P204F,P205F and/or P20FE is detected.




A

B

END