Home › Engine / Hybrid System › N04C-WA (ENGINE CONTROL) › ECD SYSTEM › from 2019.08
RM2850E _51 Engine / Hybrid System _082611 N04C-WA ENGINE CONTROL _0399963 ECD SYSTEM Y

N04C-WA ENGINE CONTROL  ECD SYSTEM  BASIC INSPECTION  


CAUTION / NOTICE / HINT

When a malfunction cannot be confirmed by checking DTCs, troubleshooting should be performed on all circuits that are possible causes of the problem. However, in most cases, performing the basic engine check shown below can help you find the problem quickly and efficiently. Always perform this check first when troubleshooting the engine.

PROCEDURE

1.CHECK BATTERY VOLTAGE
NOTICE:

Check the battery voltage with the engine stopped and the ignition switch off.


Result:
Result Proceed to
11 V or higher OK
Below 11 V NG



OK

2.CHECK IF ENGINE CRANKS

NG

CHARGE OR REPLACE BATTERY

2.CHECK IF ENGINE CRANKS
Result:
Proceed to
OK
NG



OK

3.CHECK AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

NG

PROCEED TO PROBLEM SYMPTOMS TABLE

3.CHECK AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
a.

Visually check that the air cleaner filter sub-assembly is not excessively contaminated with dirt or oil.


Result:
Proceed to
OK
NG



OK

4.CHECK FUEL QUALITY

NG

CLEAN OR REPLACE AIR FILTER

4.CHECK FUEL QUALITY
a.

Check that only diesel fuel is present.


b.

Check that the fuel does not contain any impurities.


Result:
Proceed to
OK
NG



OK

5.CHECK FUEL SYSTEM FOR AIR

NG

DRAIN AND REFILL FUEL

5.CHECK FUEL SYSTEM FOR AIR
Result:
Proceed to
OK
NG



OK

6.CHECK FUEL PIPES AND HOSES

NG

BLEED AIR FROM FUEL SYSTEM

6.CHECK FUEL PIPES AND HOSES
a.

Check that the fuel pipes and fuel hoses are not blocked, damaged, disconnected or bent.


Result:
Proceed to
OK
NG



OK

7.CHECK FUEL FILTER FOR BLOCKAGE

NG

REPAIR OR REPLACE

7.CHECK FUEL FILTER FOR BLOCKAGE
Result:
Proceed to
OK
NG



OK

8.CHECK ENGINE OIL

NG

CLEAN OR REPLACE

8.CHECK ENGINE OIL
Result:
Proceed to
OK
NG



OK

9.CHECK ENGINE COOLANT

NG

ADD OR DRAIN AND REFILL

9.CHECK ENGINE COOLANT
Result:
Proceed to
OK
NG



OK

10.CHECK IDLE SPEED AND MAXIMUM ENGINE SPEED

NG

ADD OR DRAIN AND REFILL ENGINE COOLANT

10.CHECK IDLE SPEED AND MAXIMUM ENGINE SPEED
HINT:

If the result not as specified, perform troubleshooting according to the symptoms table.


Result:
Proceed to
NEXT



NEXT

11.CHECK DIAGNOSTIC CIRCUIT
11.CHECK DIAGNOSTIC CIRCUIT
Result:
Proceed to
OK
NG



OK

12.CHECK VACUUM PUMP

NG

REPAIR OR REPLACE

12.CHECK VACUUM PUMP
Result:
Proceed to
OK
NG



OK

PROCEED TO PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE VACUUM PUMP