OPERATION CONDITIONS
Power slide door main switch off.
Turn the ignition switch to ON.
Vehicle speed 5 km/h (3 mph) or less.
Slide door lock remote control (emergency controller) not operated.
CHECK BASIC OPERATIONS
When the door control switch assembly (open switch) is pressed and held with the center door fully closed, check that the buzzer sounds for 0.8 seconds and a center door open operation is performed.
When the open operation is complete, the buzzer sounds for 0.8 seconds.
When the door control switch assembly (close switch) is pressed and held with the center door fully open, check that the buzzer sounds for 0.8 seconds and a center door close operation is performed.
While a close operation is being performed, the buzzer sounds intermittently at 0.4-second intervals.
When the close operation is complete, the buzzer sounds for 0.8 seconds.
CHECK OPERATION WHEN ANOTHER INPUT DETECTED DURING OPEN AND CLOSE OPERATIONS
When the door control switch assembly (close switch) is released while a center door close operation is being performed, check that the center door stops at that position. When the door control switch assembly (close switch) is pressed again, check that the buzzer sounds for 0.8 seconds and the door restarts close operation.
While the center door operation is suspended, the buzzer sounds intermittently
When the door control switch assembly (open switch) is released while a center door open operation is being performed, check that the center door stops at that position. When the door control switch assembly (open switch) is pressed again, check that the buzzer sounds for 0.8 seconds and the door restarts open operation.
While the center door operation is suspended, the buzzer sounds intermittently.
OPERATION CONDITION NOT MET DURING OPEN AND CLOSE OPERATIONS
When the door control switch assembly is released while a center door open or close operation is being performed, check that the magnetic clutch is engaged for 30 minutes, and then the normal brake control mode is switched to the strong brake control mode.
While the center door operation is suspended, the buzzer sounds intermittently.
CHECK JAM PROTECTION FUNCTION
Check jam protection function during center door open operation
Perform a center door open operation.
When the center door is forcibly stopped by hands, etc., during a center door open operation, check that the buzzer sounds twice and that the center door reverses operation for a certain distance and then stops at that position.
While the center door is in operation in the reverse direction, when the movement is obstructed again, the center door does not perform a reverse operation. Instead, the brake control mode becomes active.
Check jam protection function during center door close operation
Perform a center door close operation.
When the center door is forcibly stopped by hands, etc., during a center door close operation, check that the buzzer sounds twice and that the center door reverses operation until it reaches the fully open position.
While the center door is in operation in the reverse direction, when the movement is obstructed again, the center door does not perform a reverse operation. Instead, the brake control mode becomes active.
CHECK MANUAL OPERATIONS
Power slide door main switch is on.
When the slide door lock remote control (emergency controller) is operated, check that the center door can be opened or closed manually.
When the slide door lock remote control (emergency controller) is operated without pressing the power slide door main switch, it is possible to operate the center door manually, however, the buzzer keeps sounding.
The buzzer stops sounding when any of the following conditions is met.
Center door is fully closed and slide door lock remote control (emergency controller) is not operated.
Power slide door main switch (driver side orcenter door side) is ON.
300 seconds have elapsed since the buzzer sounded.