Home › Engine / Hybrid System › N04C-WA (EMISSION CONTROL) › DIFFERENTIAL PRESSURE SENSOR › from 2019.08
RM2850E _51 Engine / Hybrid System _082614 N04C-WA EMISSION CONTROL _0400257 DIFFERENTIAL PRESSURE SENSOR A

N04C-WA EMISSION CONTROL  DIFFERENTIAL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89480A 1.INSTALL DIFFERENTIAL PRESSURE SENSOR ASSEMBLY

a.

Connect the No. 1 air hose and No. 2 air hose to the differential pressure sensor and slide the 2 new clips to secure the hose.

NOTICE:
·

Make sure that the hose is not loose, twisted or bent.

·

Do not damage the inside or outside of the hose during installation.

·

If the hose is damaged, replace the hose with a new one.




b.

Install the differential pressure sensor assembly to the sensor bracket with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

Install the sensor bracket with the 2 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


d.

Connect the No. 1 air hose and No. 2 air hose to the No. 1 exhaust pipe converter assembly and slide the 2 new clips to secure the hose.

NOTICE:
·

Make sure that the hose is not loose, twisted or bent.

·

Do not damage the inside or outside of the hose during installation.

·

If the hose is damaged, replace the hose with a new one.



HINT:

Connect the hose correctly.



e.

Connect the differential pressure sensor assembly connector.