Vehicle communication CAN bus A is connected to the CAN terminator, ECM, EGR, VNT, No. 1 NOx sensor, No. 2 NOx sensor, PM sensor, urea solution quality sensor (urea sensor assembly) and DCU (emission control ECU assembly).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Warning Indicate | Memory |
|---|---|---|---|---|---|---|
| U002988 | Vehicle Communication Bus A Performance Bus off | Diagnosis Condition:
·
Ignition switch ON. ·
Battery voltage is 9 V to 16 V. Malfunction Status: ·
DCU (emission control ECU assembly) cannot receive all messages from CAN A. Malfunction Duration: ·
1 second or more. |
·
CAN communication system ·
DCU (emission control ECU assembly) |
Class A | AdBlue consumption warning light:
Does not come on |
DTC stored |
Interruption in CAN communication is detected.
After having restored to the normal conditions.
| DTC No. | DTC Detection Drive Pattern |
|---|---|
| U002988 | Ignition switch ON for 1 second or more. |
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Urea Selective Catalytic Reduction / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
|---|---|
| DTC U002988 is output | A |
| DTC U002988 is not output | B |
A
B
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING