Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM(w/ Brake pedal Load Sensing Switch) › from 2019.08
RM2850E _54 Brake _073264 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0356878 ANTI-LOCK BRAKE SYSTEM(w/ Brake pedal Load Sensing Switch) D

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM(w/ Brake pedal Load Sensing Switch)  SYSTEM DESCRIPTION  


FUNCTION DESCRIPTION


a.

ABS (Anti-lock Brake System)

i.

The ABS helps prevent the wheels from locking when the brakes are applied firmly or when braking on a slippery surface.



b.

EBD (Electronic Brake force Distribution)

i.

The EBD control utilizes ABS, and performs proper brake force distribution between the front and rear wheels in accordance with driving conditions. When braking while cornering, it also controls the brake forces of the right and left wheels, helping to maintain vehicle stability.



c.

Brake pressure increase function

i.

The primary purpose of the brake pressure increase function is to provide auxiliary brake force to assist the driver if a brake booster effect is decreasing or a brake booster is failing, thus helping to maximize the brake performance of the vehicle.



d.

BA (Brake Assist)

i.

The primary purpose of the brake assist system is to provide auxiliary brake force to assist the driver if the driver cannot generate a large enough brake force during emergency braking, thus helping to maximize the brake performance of the vehicle.




FUNCTION OF COMPONENTS


Component Function
Brake Actuator Assembly Skid Control ECU Judges the vehicle driving condition based on the signals from each sensor, and sends the brake control signals to the brake actuator assembly.
Master Cylinder Pressure Sensor Assembled in the brake actuator assembly, detects the master cylinder pressure.
Pump Motor Drives the pumps inside the brake actuator assembly.
Solenoid Valves
·

The hydraulic circuit has 2 master cylinder cut solenoid valves, 4 pressure holding solenoid valves and 4 pressure reduction solenoid valves.

·

Change the fluid path based on the signals from the skid control ECU during the operation of the brake control system functions, in order to control the fluid pressure applied to the wheel cylinders.


Skid Control ECU Motor Relay Supplies power to the pump motor.
Solenoid Relay Supplies power to the solenoid valves.
Speed Sensor Detects the wheel speed of each of the 4 wheels.
Vacuum Sensor Assembly No. 1 Vacuum Booster Pressure Sensor
No. 2 Vacuum Booster Pressure Sensor
Detects the internal pressure of vacuum booster.
Stop Light Switch Assembly Detects the brake pedal depressing signal.
ECM
·

Sends the throttle position signal, accelerator pedal position signal and engine speed signal etc., to the skid control ECU.

·

Controls the engine output based on the signals received from the skid control ECU.


Brake with Switch Pedal Sub-assembly Brake Pedal Load Sensing Switch Detects the brake pedal load.
Brake Master Cylinder Reservoir Assembly Brake Fluid Level Warning Switch Detects the brake fluid level.
Airbag ECU Assembly Yaw Rate and Acceleration Sensor
·

The airbag ECU assembly incorporates the yaw rate sensor and acceleration sensor.

·

Detects the vehicle's yaw rate.

·

Detects the vehicle's acceleration in the forward, rearward and lateral directions.


Spiral with Sensor Cable Sub-assembly Steering Angle Sensor Detects the steering direction and angle of the steering wheel.
Combination Meter Assembly ABS Warning Light Illuminates to alert the driver when the skid control ECU detects a malfunction in the ABS.
Brake Warning Light
·

Illuminates to alert the driver when the skid control ECU detects a malfunction in the EBD or brake system.

·

Illuminates to alert the driver when the brake fluid level is low.