Home › Engine / Hybrid System › N04C-WA (EMISSION CONTROL) › FUEL PRESSURE SENSOR › from 2019.08
RM2850E _51 Engine / Hybrid System _082614 N04C-WA EMISSION CONTROL _0402315 FUEL PRESSURE SENSOR G

N04C-WA EMISSION CONTROL  FUEL PRESSURE SENSOR  INSPECTION  


PROCEDURE

Hide 89458G 1.INSPECT NO. 2 FUEL PRESSURE SENSOR

a.

Check the No. 2 fuel pressure sensor output voltage.

i.
A407436C01
0.76,0.354 0.948,0.354 0.948,0.354 1.281,0.719 true 2.323,0.375 2.135,0.375 2.135,0.375 1.844,0.708 true 0.052,0.052 0.292,0.25 0.24,0.198 10 false *a 1.646,1.823 1.844,2.01 0.198,0.188 10 false *b 0.521,0.302 0.75,0.479 0.229,0.177 10 false VC 2.375,0.313 2.604,0.49 0.229,0.177 10 false E2
*a Component without harness connected
(No. 2 Fuel Pressure Sensor)
*b Voltage Applied between Terminals


Apply 5 V between terminals 3 (VC) and 1 (E2).

NOTICE:
·

Be careful when connecting the leads, as the No. 2 fuel pressure sensor may be damaged if the leads are connected to the wrong terminals.

·

Do not apply more than 6 V to terminals 3 (VC) or 1 (E2).



HINT:

If a stable power supply is not available, connect 4 nickel-metal hydride batteries (1.2 V each) or equivalent in series.



ii.
A407437C01
1.479,1.792 1.479,1.635 1.479,1.635 1.719,1.177 true 2.104,1.792 2.104,1.635 2.104,1.635 2,1.167 true 0.042,0.042 0.271,0.24 0.229,0.198 10 false *a 1.396,1.833 1.625,2.01 0.229,0.177 10 false PR 2.042,1.823 2.271,2 0.229,0.177 10 false E2
*a Component without harness connected
(No. 2 Fuel Pressure Sensor)


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
2 (PR) - 1 (E2) Pressure not applied to No. 2 fuel pressure sensor Approximately 0.38 to 0.62 V*


*: The output voltage changes depending on the voltage applied to the terminals.

If the result is not as specified, replace the No. 2 fuel pressure sensor.