Home › Engine / Hybrid System › N04C-WA (ENGINE CONTROL) › PARTICULATE MATTER SENSOR › from 2019.08
RM2850E _51 Engine / Hybrid System _082611 N04C-WA ENGINE CONTROL _0403532 PARTICULATE MATTER SENSOR A

N04C-WA ENGINE CONTROL  PARTICULATE MATTER SENSOR  INSTALLATION  


PROCEDURE

Hide 894A1 1.INSTALL PARTICULATE MATTER SENSOR

a.
A450269C01
0.875,1.448 1.063,1.448 1.063,1.448 1.427,1.063 true 2.323,0.781 2.542,0.969 0.219,0.188 10 true *a 0.531,1.354 0.854,1.542 0.323,0.188 10 true SST
*a Torque Wrench Fulcrum Length


Using SST, install the particulate matter sensor.

SST
09224-00030  

Torque:
Specified tightening torque : 50 N*m (510 kgf*cm, 37 ft.*lbf)

NOTICE:

Replace with a new part if it is dropped or if it receives a strong impact.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 40 mm (1.58 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)): 43.2 N*m (441 kgf*cm, 32 ft.*lbf)




b.

Connect the particulate matter sensor with the 2 bolts.

Torque:
12.5 N*m (127 kgf*cm, 9 ft.*lbf)


c.

Connect the connector and 4 clamps.